Solved: Hunt Pilot using VG224 analog lines

MICHAEL CICCONE · ‎06-17-2010

I'm trying to setup a hunt pilot using serveral analog lines from my vg224. When I use these DN numbers assoicated with the VG

224 I get a busy signal. if I use any other DN number, such as an IP phone the Hunt pilot works correctly. Since it works correctly with

the IP Phone DN number, I'm guessing I have the hunt pilot configured correctly. Is there any reason why it won't work with DN numbers assoicated with a VG224 device? I'm using Call Manager 6.1.4.2000-5. VG224 IOS is 12.4(24)T3

Thanks

Mike C.

Rob Huffman · ‎06-17-2010

Hi Mike,

The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that should fix it."

Hope this helps!

Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

View solution in original post

Rob Huffman · ‎06-17-2010

Hi Mike,

The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that should fix it."

Hope this helps!

Rob

Please support CSC Helps Haiti

https://supportforums.cisco.com/docs/DOC-8895

https://supportforums.cisco.com/docs/DOC-8727

MICHAEL CICCONE · ‎06-17-2010

Rob,

Thanks so much for the quick response... Its working now.

Cheers

Mike

Rob Huffman · ‎06-17-2010

Hey Mike,

Glad to be of some small help here my friend

Cheers!

Rob

saif musa · ‎08-10-2016

Thanks, the post was helpful for me also