Indoor mesh with 2106 and 1131 AG

Answered Question
Jun 17th, 2010

Hello all,

   I am trying to create a 1 root 2 map indoor mesh using the 2106 controller and 1131 AG AP's.  Code train is 7.0.98.  I convert the first AP to bridge mode prior to assigning it as the root and the AP reboots and never rejoins the controller.  I wind up having to delete the private config before it will rejoin.  So I have 2 questions: 1. will this hardware/software combination work and 2. if it will work where am I going wrong?

Thanks in advance!

Bill

I have this problem too.
0 votes
Correct Answer by dancampb about 6 years 5 months ago

You are fine with that hw/sw combo.  Did you add the AP's mac address to the mac filter list on the controller?  When an AP is in bridge mode it has to be added to the mac filter list to be able to join.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4.5 (2 ratings)
Loading.
Correct Answer
dancampb Thu, 06/17/2010 - 10:05

You are fine with that hw/sw combo.  Did you add the AP's mac address to the mac filter list on the controller?  When an AP is in bridge mode it has to be added to the mac filter list to be able to join.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode