06-17-2010 06:10 AM - edited 07-03-2021 06:53 PM
Hello all,
I am trying to create a 1 root 2 map indoor mesh using the 2106 controller and 1131 AG AP's. Code train is 7.0.98. I convert the first AP to bridge mode prior to assigning it as the root and the AP reboots and never rejoins the controller. I wind up having to delete the private config before it will rejoin. So I have 2 questions: 1. will this hardware/software combination work and 2. if it will work where am I going wrong?
Thanks in advance!
Bill
Solved! Go to Solution.
06-17-2010 10:05 AM
You are fine with that hw/sw combo. Did you add the AP's mac address to the mac filter list on the controller? When an AP is in bridge mode it has to be added to the mac filter list to be able to join.
06-17-2010 10:05 AM
You are fine with that hw/sw combo. Did you add the AP's mac address to the mac filter list on the controller? When an AP is in bridge mode it has to be added to the mac filter list to be able to join.
06-18-2010 08:01 PM
_
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide