RVS-4000 V1.3.2.0 Error Message? Dead loop on virtual device sit1, fix it urgently!

bruce.hobson · ‎06-17-2010

People,

Looks like I have another cryptic message from my RVS-4000 V1.3.2.0:

Jun 13 16:54:50 - Dead loop on virtual device sit1, fix it urgently!

Jun 13 16:54:53 - Dead loop on virtual device sit1, fix it urgently!

Jun 13 16:54:59 - Dead loop on virtual device sit1, fix it urgently!

Remember, my RVS-4000 is setup for 0-3 Log Levels:

Log Level

Setting which level log Router should recorder. Level from 0 ~ 7 means:

0: LOG_EMERG(system is unusable)

1: LOG_ALERT(action must be taken immediately)

2: LOG_CRIT(critical conditions)

3: LOG_ERR(error conditions)

4: LOG_WARNING(warning conditions)

5: LOG_NOTICE(normal, but significant, condition)

6: LOG_INFO(informational message)

7: LOG_DEBUG(debug-level message)

So, when I get any messages... I'm a little concerned. Because the RVS-4000 V1.3.2.0 thinks it's an Error or better.

Thanks ahead of time!

Bruce :-|

aaronkirsten · ‎07-18-2010

I was receiving this message too. Until I set IP Mode to IPv4 Only. Error messages stopped.

This may not be very helpful if you need IPv6. But I suspect you don't because I think this error message implies that something is very wrong with IPv6 configuration. If you needed it, you'd have noticed that it wasn't working. Look here: http://linux.die.net/man/8/isatapd

Surely there are other ways to say whatever it is this message is saying so I think it is probably safe to assume it is the exact same code that generated the error for the same reason.

bruce.hobson · ‎11-06-2010

Thank you for this information...

I will try turning IPV6 off.

Bruce