Cisco 881GW dynamic failover between WAN and 3G using VPN and NAT

Unanswered Question
Jun 17th, 2010

Need help any suggestion are greatly appreciated...

--Desired result: Established an encrypted connection to corporate office (ASA 5520) to support voice and data , while providing dynamic failover

  over the 3G cell connection.  All traffic must be encrypted.

--Situation:  So the orignal router was replaceed with a 881g so we cound have the 3G as a backup connection.  The orignal setup used EZVPN as these routers contantly "traveled" to support our team.  So as I transfered the config to the new router, I ran into an issue where you can only apply the "Crypto Ipsec ezvpn name outside" command to one interface.  My initial thought process was setup both connection and use a floating route to redirect traffic.

--Solution: ??

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion

Related Content