06-17-2010 10:59 PM - edited 03-04-2019 08:49 AM
Hi,
Anyone know the throughput of IPSEC for Cisco 1921 (3DES)?
11-10-2011 03:12 AM
The SEC-K9 permanent licenses apply to the Cisco 1900, 2900, and 3900 ISR G2 platforms; these licenses limit
all encrypted tunnel counts to 225 tunnels maximum for IP Security (IPsec), Secure Sockets Layer VPN (SSL
VPN), a secure time-division multiplexing (TDM) gateway, and secure Cisco Unified Border Element (CUBE) and
1000 tunnels for Transport Layer Security (TLS) sessions.
The SEC-K9 license limits encrypted throughput to less than or equal to 85-Mbps unidirectional traffic in or out of
the ISR G2 router, with a bidirectional total of 170 Mbps. This requirement applies for the Cisco 1900, 2900, and
3900 ISR G2 platforms.
Thanks
Ajay
11-10-2011 04:56 AM
Hi Marcus,
By default it is 8 Mbps with k9 bundle.
If you enable datak9 license on that then you can configure the throughput based on your original WAN link capacity.
In my case, recently I have experienced that in my 1921 router at one site, the original link capacity is 10 Mbps but the throughput under the tunnel is just 8 Mbps.
After I enabled the datak9 license I was able to define the throughput under the tunnel to 10 Mbps.
Please rate the helpfull posts.
Regards,
Naidu.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide