cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
680
Views
0
Helpful
2
Replies

4900M with CNA

tohoken
Level 1
Level 1

All,

We have just received a 4900M switch and I am unfamiliar with this model.  I am wondering if someone could guide me in setting up the management port for access via the Cisco Network Assistant?

I have the IP info setup and I can ping the switch but the CNA throws an error when trying to connect.

Any help would be appreciated.

Ken

2 Replies 2

Leo Laohoo
Hall of Fame
Hall of Fame

I'm not familiar with this model either but why not try CLI?

conf t

interface VLAN 1

ip address

no shutdown

end

wr

Hope this helps.

ericngimme
Level 1
Level 1

The 4900M is a bit tricky since the force vrf policies on the switch.  This is my recommendation:

Switch# ping vrf  mgmtVrf ip address

an example is "ping vrm mgmtVrf 20.20.20.20" (or whatever IP you are looking for)

Trace Routing is the same thing...

"traceroute vrf mgmtVrf 20.20.20.20"

Remember that the vrf (name of vrf) is cap sensitive.  So it must match the exact syntax you have setup.  By default, 4900Ms use mgmtV(cap V)rf.

I really cant help you with the GUI Network assistant but I can help with CLI.

Here is a link that may help:

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/52sg/configuration/guide/sw_int.html#wp1110617

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: