Roam Testing to Millisecond

Elliott Shawd · ‎06-20-2010

Is there a way to change the controller time stamp to include milliseconds in the CLI? Or, is there another way to test roaming to the millisecond?

dancampb · ‎06-21-2010

If you have autonomous AP's just setup the logging to show the millisecond with "service timestamps log datetime msec"

If you have a controller the debug client output shows the milliseconds.

Elliott Shawd · ‎06-24-2010

I can't see the milliseconds on the controller debug. I get:

Thu Jun 24 08:33:51 2010: 00:16:6f:6e:88:15 10.34.72.133 RUN (20) Change state to START (0) last state RUN (20)

Thu Jun 24 08:33:51 2010: 00:16:6f:6e:88:15 10.34.72.133 START (0) Initializing policy

We are running code 4.2.207.0.

jfraasch · ‎06-24-2010

In routers it would be:

service timestamps debug date local msec

service timestamps log date local msec

This will add the msecs to the log and debug lines.

James

Elliott Shawd · ‎06-24-2010

That doesn't work for me. I don't get those options.

(ak650-wism-s4-2) config>service timestamps debug ?

datetime Timestamp debug messages with standard date and time.

disable Do not timestamp debug messages.

uptime Timestamp debug messages with time since last reset.

(ak650-wism-s4-2) config>service timestamps debug datetime ?

(ak650-wism-s4-2) config>service timestamps debug datetime

(ak650-wism-s4-2) config>service timestamps log

datetime Timestamp log messages with standard date and time.

disable Do not timestamp log messages.

uptime Timestamp log messages with time since last reset.

(ak650-wism-s4-2) config>service timestamps log datetime ?

(ak650-wism-s4-2) config>service timestamps log datetime