cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1034
Views
0
Helpful
4
Replies

CUPC 7.0 silent install

William Maguire
Level 1
Level 1

All,

   Hopefully really simple question.  We have finished out beta of CUPC and are ready to begin a limited rollout.  Is there a way to set the cupc .msi package for a silent install.  I have looked around and can't find any procedure for this documented.

Thanks,

Bill

1 Accepted Solution

Accepted Solutions

You can't. This information exists in an XML file on the local disk. You will need an MST or a logon script that pre-seeds the default XML file which will be copied when the user launches CUPC. We have covered this before here: https://supportforums.cisco.com/message/3008466#3008466

View solution in original post

4 Replies 4

Jonathan Schulenberg
Hall of Fame
Hall of Fame

It's a standard MSI so the normal msiexec options should apply. Have you tried using the msiexec /quiet parameter?  Whatever your normal package deployment method is should work for CUPC.

Thanks, I had hoped that was the case, but what I was more asking (and not asking really well)

was where in the installer can I give it the name of the presence server

and any other options.

You can't. This information exists in an XML file on the local disk. You will need an MST or a logon script that pre-seeds the default XML file which will be copied when the user launches CUPC. We have covered this before here: https://supportforums.cisco.com/message/3008466#3008466

Sorry to make you go over old ground but I truly appreciate the fast reply.  This giv

es me a good starting point.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: