ISR-G2 Router

Answered Question
Jun 21st, 2010

Dear All,

I have a 2921 ISR-G2 router in working condition. I configured the router first time and log out without changing the password and in ISR-G2 it is must to change the password before logging out.

now it is not allowing me to login again.

plaese help me to login again or any password recovery procedure.

Thanks,

Nitin

I have this problem too.
0 votes
Correct Answer by Leo Laohoo about 6 years 5 months ago

Password Recovery Procedure for the Cisco 2900 Integrated Services Router

http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml#procedure

If you can't go into ROMmon:

At the back of the router, on the lower left-hand corner, is where the CF are located.  It's found behind the covers which you can use a small flat-head s crew driver to lift the covers.  Remove one or both of the covers and eject the CF.   Reboot your router and you should be in ROMmon.  Don't forget to insert the CF back.

Don't forget to rate useful posts.  Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Leo Laohoo Mon, 06/21/2010 - 22:30

Password Recovery Procedure for the Cisco 2900 Integrated Services Router

http://www.cisco.com/en/US/products/ps5854/products_password_recovery09186a0080b34901.shtml#procedure

If you can't go into ROMmon:

At the back of the router, on the lower left-hand corner, is where the CF are located.  It's found behind the covers which you can use a small flat-head s crew driver to lift the covers.  Remove one or both of the covers and eject the CF.   Reboot your router and you should be in ROMmon.  Don't forget to insert the CF back.

Don't forget to rate useful posts.  Thanks.

Leo Laohoo Mon, 06/21/2010 - 22:47

Happy to provide assistance and thank you very much for the ratings. 

Actions

This Discussion