FXO and Caller ID

Unanswered Question
Jun 23rd, 2010
User Badges:

Hi all,


I have 3845 router added to CCM as H.323 gateway.


I am using this IOS : c3845-advipservicesk9-mz.124-3i.bin


and it contains 2 VIC2-4FXO cards.


I added the configuration :


caller-id enable

caller-id alerting ring " 2 and sometime 1"


I tried to change the cp tone and other parameters but no luck.


I used : debug vpm signal and I found:


get_fxo_caller_id:Caller ID receive failed.  parseCallerIDString:no data.


but when if I connect analog phone to the line directly I can find the caller ID.


one more thing: When I can use the command:


caller-id alerting dsp-pre-allocate


sometimes I am able to find the dsp-pre-allocate and sometimes no?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Md. Mijanur Rahman Wed, 06/23/2010 - 11:50
User Badges:
  • Bronze, 100 points or more

Hi,


Please search first on the space before posting.

Follow the steps:

     1. Connect an analog phone and confirm if your service provider is sending the caller-id,

     2. If they are sending properly this is most likely a well known bug if you are facing on H.323 mode, upgrade the IOS to any 12.4(20)T or higher.


This post might help you!

https://supportforums.cisco.com/message/1148237


HTH.

Please rate helpful posts!

Actions

This Discussion