cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
404
Views
0
Helpful
1
Replies

Ciscoworks Device Discoverya

dtom
Level 1
Level 1

How does Ciscoworks determine what address to use on a device (router)?  We have a 3845 with the following configuration:

interface GigabitEthernet0/0
description Cloud 2 10.0.2.x
ip address 10.0.2.83 255.255.255.0
duplex auto
speed auto
media-type sfp
!
interface GigabitEthernet0/1
description Local Network
no ip address
duplex auto
speed auto
media-type rj45
!
interface GigabitEthernet0/1.1
description Legacy Network
encapsulation dot1Q 1 native
ip address 172.22.52.1 255.255.255.0 secondary
ip address 172.22.51.1 255.255.255.0 secondary
!
interface GigabitEthernet0/1.3
description Student Vlan
encapsulation dot1Q 3
ip address 10.83.3.1 255.255.255.0
!

The only address that we see in Ciscoworks is 10.0.2.83.  Should we see all addressess from this router

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

If you're asking how does Discovery decide what address to use when adding the device to DCR, see this document:

https://supportforums.cisco.com/docs/DOC-9005

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco