Solved: clear config - interface

dkblee · ‎06-23-2010

hi! what's the command to clear an gigaethernet internface config on a 4506e sw? currently there are lots of qos and security stuffs on some of the gigaethernet port. instead of using the no command for each of the line, is there a command to clear all these config? i just want to configure access vlan on the port.

thx.

Lim Seow Hua · ‎06-23-2010

You can try to use below command on the configuration mode....

xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.

And let me know later

View solution in original post

Lim Seow Hua · ‎06-23-2010

You can try to use below command on the configuration mode....

xxx-xxx(config)#default interface gigabitEthernetx/x - specify the port that you would like to clear the configuration...see whether it works or not.

And let me know later

Asbathc786 · ‎01-05-2016

Hi there,

I tried the above command and it works.

Thanks,

wgottlieb · ‎05-12-2016

Worked for me too, thanks!

jessemeddaugh · ‎07-11-2019

Worked for me as well.

Thanks!

Joseph W. Doherty · ‎07-11-2019

BTW, I recall the interface default command can be use with the interface range command too.

MrFollis · ‎10-17-2021

Thank you!!

I did have to type it as autocomplete wouldn't work for some reason?

Either way it worked and thank you !!!