SPA-4X1FE-TX-V2 out of service in ASR1006

vikaskohli2 · ‎06-24-2010

Hi need your help

on enabling

Slot Type State Insert time (ago)

0/1 SPA-4X1FE-TX-V2 out of service

Slot CPLD Version Firmware Version

--------- ------------------- ---------------------------------------

0 07091401 12.2(33r)XN

1 07091401 12.2(33r)XN

R0 07062111 12.2(33r)XN2

F0 07051680 12.2(33r)XN

Jun 23 23:05:29.085: %ASR1000_SIP_SPA-3-SPI4_NOTSYNC: SIP0/1: SPA-4X1FE-TX-V2[0/1]: Can not synchronize SPI4 bus (host:

src in sync, sink in sync, spa: src not in sync, sink in sync).

*Jun 23 23:05:30.982: %LINEPROTO-5-UPDOWN: Line protocol on Interface POS0/0/0, changed state to down

*Jun 23 23:05:30.982: %LINEPROTO-5-UPDOWN: Line protocol on Interface POS0/0/1, changed state to down

Brandon Lynch · ‎06-28-2010

The SPA will go out of service in this instance if the SPI4 synchronization fails 5 times. This can be the result of a mis-seated card or a hardware failure. Please try the following -

1) First, re-seat the SPA in the same slot that it is currently in to see if it comes back online.

2) If it doesn't, try to insert the SPA in a different slot of the same SIP if any are available.

3) If this still fails, try to insert the SPA into a different SIP if possible to see if it comes online there.

If the SPA comes online in a different slot of the SIP but fails in the current slot, this is likely a hardware issue with the SIP. If it fails to come online at all, this is likely a problem with the SPA. Hope this helps.