SRW248G4P in constant boot loop.

stsnetswim · ‎06-24-2010

I just purchased this SRW248G4P switch, powered it up and initially I was able to get into the console port and perform initial configurations. I connected another switch to one of the Gigabit ports and performed my configuration changes via the web browser. Upon reboot, it went into a constant diagnostic reboot loop below. Any ideas on what I can do to fix this, or am I talking RMA?

Image Loader 1.0.1
Loading Diagnostic Image File : SRW224G4P_SRW248G4P_boot.bix
Diagnostic 1.0.1

Thanks,

Chris B

David Hornstein · ‎06-25-2010

Ah Chris,

I hope we are not talking about RMA, costs us both time and money.

Give the good folk at the Small Business Support center a call via the following URL.

http://www.cisco.com/en/US/support/tsd_cisco_small_business_support_center_contacts.html

regards Dave