video conference equipment QoS setting

Answered Question
Jun 24th, 2010
User Badges:

Hi


I have network which everywhere set mls qos trust dscp and quto qos. normally, I setup video conference equipment to se QoS as video AF41,CS4 and voice EF.


now, there is one video equipment, it has only one bit for QoS. Could anyone advice me which value I should use to much my network QoS enviromant? AF41 or EF?


Any comments will be appreciated


Thanks in advance


Julxu

Correct Answer by Aaron Harrison about 6 years 11 months ago

Hi


In general; a video device that doesn't mark voice and video seperately would be marked AF41. This is because the characteristics of the traffic are very different - video is very bursty, and may be very bandwidth hungry so isn't always a good thing to put in absolute priority queues where it might choke out other traffic including voice.


Aaron


Please rate helpful posts...

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Aaron Harrison Thu, 06/24/2010 - 23:36
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


In general; a video device that doesn't mark voice and video seperately would be marked AF41. This is because the characteristics of the traffic are very different - video is very bursty, and may be very bandwidth hungry so isn't always a good thing to put in absolute priority queues where it might choke out other traffic including voice.


Aaron


Please rate helpful posts...

Actions

This Discussion