I installed an NME-CUE module on a 2821 MGCP gateway which is registered with a CM 6.1.
The problem is that after the installation I cannot see in CLI any new interface in order to program the CUE. (interface Integrated-Service-Engine)
If I run the "show inventory" command I have the following output. Why the NME-CUE module has an "Unknown" name and description?
NAME: "2821 chassis", DESCR: "2821 chassis, Hw Serial#: FCZ12357830, Hw Revision: 52.57"
PID: CISCO2821 , VID: V04 , SN: FCZ12357830
NAME: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1", DESCR: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1"
PID: VWIC2-1MFT-T1/E1 , VID: V01 , SN: FOC12333SJD
NAME: "PVDMII DSP SIMM with Two DSPs", DESCR: "PVDMII DSP SIMM with Two DSPs"
PID: PVDM2-32 , VID: V01 , SN: FOC122819S1
NAME: "Unknown", DESCR: "Unknown"
PID: NME-CUE , VID: V01 , SN: FOC12340EAL