06-24-2010 11:53 PM - edited 03-13-2019 07:02 PM
Hi,
I am configuring a voice gateway, and have added the media flow-through command in the dial peer, the IOS takes the command, but when I give the sh run it is not shown under dialpeer, but the same is shown under the sh dial peer voice command. Any suggessions!!!
Thanks and Regards
Anil
06-25-2010 12:10 AM
Hi
I think this command is like a default, so it isn't shown in the configuration.
If you enter media flow-around, do you see that? If so, then you put in media flow-through again and it disappears this confirms it.
From the command ref:
To enable media packets to pass directly between the endpoints, without the intervention of the IP-to-IP gateway (IPIPGW), use the media command in dial-peer, voice-class, or voice-service configuration mode. To return to the default IPIPGW behavior, use the no form of this command.
media [flow-around | flow-through | statistics]
no media [flow-around | flow-through | statistics]
The default behavior of the IP-to-IP gateway is to receive media packets from the inbound call leg, terminate them, and then reoriginate the media stream on an outbound call leg.
Regards
Aaron
Please rate helpful posts...
05-24-2011 09:55 AM
Hi Aaron! Do you know what version IOS this is supported on. I thought maybe flow around was only supported in 15.x is that right?
05-25-2011 02:34 AM
Also note the command description doesn't make sens:
flow-around | # Enables media packets to pass directly between the endpoints, without the intervention of the IP-to-IP gateway (IPIPGW) The media is to flow around the gateway. |
# flow-through | # Enables media packets to pass through the endpoints, without the intervention of the IPIPGW. |
Text in bold Should be "through the IPIPGW".
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: