06-25-2010 07:13 AM - edited 03-06-2019 11:45 AM
I read that the PA-GE module on the 7200 supports an mtu of >1500. I'm trying to set mine to 1546, but cannot. What command do I enter to enable support for this size?
EDR01#config t
Enter configuration commands, one per line. End with CNTL/Z.
EDR01(config)#int gig 5/0
EDR01(config-if)#ip mtu 1546
^
% Invalid input detected at '^' marker.
EDR01 (config-if)#ip mtu ?
<68-1500> MTU (bytes)
Solved! Go to Solution.
06-25-2010 07:26 AM
Hello David,
it is also a question of IOS image
also you need first to increase mtu with mtu command then you may be able to increase ip mtu
Hope to help
Giuseppe
06-25-2010 07:26 AM
Hello David,
it is also a question of IOS image
also you need first to increase mtu with mtu command then you may be able to increase ip mtu
Hope to help
Giuseppe
06-25-2010 08:25 AM
Version 12.4 (12.2r) T
Cisco 7200
Card is PA-GE (trying to change Gig 5/0 on this card)
06-25-2010 08:28 AM
Thanks....
int gig 5/0
mtu xxxxx
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide