2911/WIC Issue

Answered Question
Jun 25th, 2010
User Badges:

New 2911 running 15.1(1)T, base,sec and data licenses and new VWIC2-1MFT-T1/E1


Shows in the inventory but cant use serial interface  commands, not showing in sh run, tried in different slots. My first 2900 series router, am I missing something ??



bva-2911#sh inventory

NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"

PID: CISCO2911/K9      , VID: V01 , SN: xxxxxxxxx


NAME: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1"

PID: VWIC2-1MFT-T1/E1  , VID: V01 , SN: xxxxxxxxxx


NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"

PID: PWR-2911-AC       , VID: V01 , SN: xxxxxxxxx



Correct Answer by John Blakley about 6 years 9 months ago

You can't set the card up with the "card type" command?


card type t1


Then you can configure the controller with the controller commands.


HTH,

John

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
John Blakley Fri, 06/25/2010 - 13:34
User Badges:
  • Purple, 4500 points or more

You can't set the card up with the "card type" command?


card type t1


Then you can configure the controller with the controller commands.


HTH,

John

Actions

This Discussion