06-25-2010 11:12 AM - edited 03-04-2019 08:53 AM
New 2911 running 15.1(1)T, base,sec and data licenses and new VWIC2-1MFT-T1/E1
Shows in the inventory but cant use serial interface commands, not showing in sh run, tried in different slots. My first 2900 series router, am I missing something ??
bva-2911#sh inventory
NAME: "CISCO2911/K9 chassis", DESCR: "CISCO2911/K9 chassis"
PID: CISCO2911/K9 , VID: V01 , SN: xxxxxxxxx
NAME: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1 on Slot 0 SubSlot 0", DESCR: "VWIC2-1MFT-T1/E1 - 1-Port RJ-48 Multiflex Trunk - T1/E1"
PID: VWIC2-1MFT-T1/E1 , VID: V01 , SN: xxxxxxxxxx
NAME: "C2911 AC Power Supply", DESCR: "C2911 AC Power Supply"
PID: PWR-2911-AC , VID: V01 , SN: xxxxxxxxx
Solved! Go to Solution.
06-25-2010 01:34 PM
You can't set the card up with the "card type" command?
card type t1
Then you can configure the controller with the controller commands.
HTH,
John
06-25-2010 01:34 PM
You can't set the card up with the "card type" command?
card type t1
Then you can configure the controller with the controller commands.
HTH,
John
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: