CAD using CIPC on CCX V8

Unanswered Question
Steven Griffin Tue, 07/06/2010 - 17:02
User Badges:
  • Silver, 250 points or more

Just a shot in the dark... Try disabling IPv6 in your network protocol stack on your PC.

joesnyde Tue, 08/03/2010 - 08:34
User Badges:
  • Cisco Employee,

Hi,


This is a new issue where CUCM is sending a null for the IPV4 field thus CAD thinks the device is using IPV6. Are the agents using Extension Mobility?


CSCti18636 Extension Mobility user can't login as UCCX  CAD Agent.


You can review more details about the bug through the bug toolkit on cco - http://tools.cisco.com/Support/BugToolKit/action.do?hdnAction=searchBugs


Regards,


Joe

blackmichael Tue, 08/03/2010 - 09:38
User Badges:

thanks for the update.  I have been workign tac on this and file that bug on my behalf.  But the work around they have posted does not work.

At this point you can use EM and UCXX running version 8.

Anthony Holloway Tue, 08/03/2010 - 14:01
User Badges:
  • Purple, 4500 points or more

Can you please calrify your last statement?  It's confusing.


Can you use EM with Desk Phones on CUCM/UCCX 8?

Can you use EM with CIPC on CUCM/UCCX 8?


Is this an issue with CUCM or UCCX?

Aaron Harrison Sat, 09/18/2010 - 14:18
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


I hit a very similar issue to this today; after upgrade from 6.1 to 8.0(3a) of CCM and 8.0(2) of UCCX I couldn't log in to CAD. Oddly if I reset the phone while the 'IPV6 not supported' error and then hit retry it allowed login, which meant I thought it was fixed and didn't troubleshoot it further...(I had set a Common Device config on the phone which enforced IPV4-only mode, so I thought that had fixed it).  This affected both 7962/7911 phones.


Later when I noticed it had not been resolved, I had started an upgrade to 8.0(2)ES1, and had also triggered a JTAPI sync prior to that; so either getting the proper version of JTAPI or upgrading to 8.0(2)ES1 resolved it in my case.


Regards


Aaron

Anthony Holloway Mon, 09/20/2010 - 08:54
User Badges:
  • Purple, 4500 points or more

Thanks for the update Aaron.


So as far as we know, in UCCX 8.0(2) ES1:


Desk Phone + EM + CAD works


and


CIPC + CAD works


Correct?

Aaron Harrison Mon, 09/20/2010 - 11:38
User Badges:
  • Super Bronze, 10000 points or more
  • Community Spotlight Award,

    Member's Choice, May 2015

Hi


Well - Deskphones with or without EM, yes... this customer doesn't use CIPC so couldn't test that.


Regards


Aaron

Actions

This Discussion