Solved: Configuring two 128 Kbps ISDNL line one 256 Kbps ISDN Line

ashraf.kazi · ‎06-26-2010

I want to connect 3 branches with ISDN line . All the branches bandwidth requirement is 256 Kbps . As I have suggested the combining 2 ISDN line in to 1 ISDN line by Multilink Group. I have confussion over the configuration .

interface BRI2/0

encapsulation ppp

dialer rotary-group 1

isdn spid1 0835866201

isdn spid2 0835866401

!

interface BRI2/1

encapsulation ppp

dialer rotary-group 1

isdn spid1 0835867201

isdn spid2 0835967401

!

interface Dialer1

ip unnumbered Ethernet0/0

encapsulation ppp

dialer in-band

dialer map ip 172.20.2.1 name kdt-nas 8358661

dialer load-threshold 100 either

dialer-group 1

ppp authentication chap callin

ppp multilink

// I don't have the SPID no , I have the ISDN No should i add the country code as well before the We DN no or how it will be in case only ISDN no . Our ISDN no is 968-24609638 , 639 . Kindl assist me to configure the ISDN .

spremkumar · ‎06-28-2010

hi

i guess its a point to point ISDN line between your locations, as far as i know you dont need to have SPID instead you can configure the remote peer isdn no.

below link provides you a simple sample config which you can try out there..

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a00800a3b7a.shtml

regds

View solution in original post

spremkumar · ‎06-28-2010

hi

i guess its a point to point ISDN line between your locations, as far as i know you dont need to have SPID instead you can configure the remote peer isdn no.

below link provides you a simple sample config which you can try out there..

http://www.cisco.com/en/US/tech/tk713/tk507/technologies_configuration_example09186a00800a3b7a.shtml

regds

ashraf.kazi · ‎06-29-2010

Thanks Prem this is the exact scenario

Rgd's

Sayed Ashraf