incoming calls ring to a dial tone

Unanswered Question
Jun 28th, 2010

uc 560

incomming calls to DID's ring to a dail tone

dial-peer voice 150 pots
  incoming called-number .T

any ideas?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Brandon Buffin Mon, 06/28/2010 - 06:50

What type of PSTN connection? PRI, POTS? If POTS, add the following to the voice port config:

voice-port 0/0/0

connection plar 100 (This will be the DN that you want incoming calls to ring to)

Hope this helps.


Brandon Buffin Mon, 06/28/2010 - 06:59

Try changing the command to "incoming called-number ."

You can also run "debug voip dialpeer" to make sure that this dial peer is being matched on an incoming call.


Abu Hadee Mon, 06/28/2010 - 07:00

do you have any other pots dial-peer?

try "debug voip ccapi inout" to find which incoming dial-peer it is matching.


- abu

Walter Solano Mon, 06/28/2010 - 08:42

Hello Michael.

Please try to change the "incoming called-number .t" to "incoming called-number .", another think that could be causing this issue its another dial-peer has been match as an incoming dial-peer please run a "debug voip CCAPI" when the call its coming into the system that will let us know which one its the true incoming dial-peer.


Please rate this post if was helpful

Walter Solano

CCVP, Cisco UCCX Specialist

Cisco IP Communications Express Specialist


This Discussion