Cisco Unified Border Element active calls MIB or API

Unanswered Question
Jun 28th, 2010

Hi! How can I monitor CUBE active calls? Is there a MIB available or an API? Can we get this value through the Cisco Unified Commuincations Manager API?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
William Bell Mon, 06/28/2010 - 08:43

I have not perused the MIBS in 15.1(1)T of IOS, but I recently attended a Cisco session where this question popped up.  Cisco has introduced several extensions to the CISCO-VOICE-DIAL-CONTROL-MIB and CISCO-DSP-MGMT-MIB mibs.  These extensions are specific to CUBE and allow for more granular (i.e. accurate) monitoring of traffic volume.  It appears that you can now get aggregate, protocol specific, dial-peer specific, and/or interface specific call rates.

Again I have not looked at this myself, but it seems that you may find what you are looking for with IOS 15.1(1)T.  Here is a link that may be a good place to start:



Please remember to rate helpful posts.


This Discussion