Cisco Unified Border Element active calls MIB or API

nimsoftdev · ‎06-28-2010

Hi! How can I monitor CUBE active calls? Is there a MIB available or an API? Can we get this value through the Cisco Unified Commuincations Manager API?

Thanks,
Sachin

William Bell · ‎06-28-2010

I have not perused the MIBS in 15.1(1)T of IOS, but I recently attended a Cisco session where this question popped up. Cisco has introduced several extensions to the CISCO-VOICE-DIAL-CONTROL-MIB and CISCO-DSP-MGMT-MIB mibs. These extensions are specific to CUBE and allow for more granular (i.e. accurate) monitoring of traffic volume. It appears that you can now get aggregate, protocol specific, dial-peer specific, and/or interface specific call rates.

Again I have not looked at this myself, but it seems that you may find what you are looking for with IOS 15.1(1)T. Here is a link that may be a good place to start:

http://www.cisco.com/en/US/docs/ios/voice/cube/configuration/guide/vb-gw-roadmap_ps5640_TSD_Products_Configuration_Guide_Chapter.html

HTH.

Regards,
Bill

Please remember to rate helpful posts.

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify