06-28-2010 12:39 PM - edited 03-06-2019 11:48 AM
I am needing to setup some ACL's on a 3560G switch Switch is running IOS). We want to restrict access to a VLAN to a select few IP addresses and ip address ranges, these would be inbound to the VLAN.
I could use examples of how best to do this.
Thanks and Regards
Edwin Collins
06-28-2010 01:08 PM
Edwin,
You can use ACL to restrict access to the vlan.
have a look at the config guide with examples
HTH
Reza
06-28-2010 11:59 PM
I am needing to setup some ACL's on a 3560G switch Switch is running IOS). We want to restrict access to a VLAN to a select few IP addresses and ip address ranges, these would be inbound to the VLAN.
I could use examples of how best to do this.
Thanks and Regards
Edwin Collins
Hi Edwin,
Check out the below link aslo for basic concept for applying acl in switches/routers
http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00800a5b9a.shtml
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: