cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1017
Views
0
Helpful
2
Replies

Send message and acknowledge

torleif
Level 1
Level 1

I need to send a message to a single phone and then acknowledge the message from the phone. The phone can be addressed by the IP address or any other way.

We use CCM 4.3.

What is the easiest way of doing this? Any programming examples or comments appreciated.

Regards,

Torleif Hovden, Norway

2 Replies 2

William Bell
VIP Alumni
VIP Alumni

What are you sending? Text? In the Phone SDK (http://developer.cisco.com,

go to the Unified Communications section) there is an application called

push2phone. You can use this to send text to the phone. There is also a

sample application which you can use to send text messages to phones. It is

just a concept app and isn't really ready for prime time. It is in the

Phone SDK readme. The Phone SDK is a bit old, but the concepts still work.

If you are looking for something robust then you may want to check out any

of the developing partners that provide paging applications. Most of the

time, these paging developers package text and audio paging into the same

app. This makes sense in a way as the moving parts are very similar. An

app I like is Cistera. But the old school Informacast can do this. As can

others.

HTH.

Regards,

Bill

HTH -Bill (b) http://ucguerrilla.com (t) @ucguerrilla

Please remember to rate helpful responses and identify

At a nursing home we use SMS messages to call for attention. We would like to send text (and audio) messages to 7925 phones instead and then acknowledge the messages with the phone.

Is it possible to acknowledge messages with the push2phone?

Torleif

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: