WAAS Pre-positioning

Unanswered Question

Hi Zach,


A question regards WAAS pre-positioning. Is there any way to determine what files (and directories from which these came) have been pushed by a pre-position policy ?? I have recently set up a couple of policies and although the system reports success, one policy has pushed no data and the second has pushed approximately half of what I was expecting.


Thanks,


Paul.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Zach Seils Tue, 06/29/2010 - 04:59
User Badges:
  • Cisco Employee,

Hi Paul,


There really isn't any report or query we can run to see exacty what directories/files were prepositioned.


What are the completion messages you are seeing for the jobs?


Zach

Thanks Zach,


Completion message indicates what could be completed has done so successfully ("Status-Completed" & "Reason-No files need to be prepositioned"). However I know that this is not the case......There are some messages I have found in the logs and also some more granular detail that can be seen in the device GUI (CifsAO - Preposition).

Zach Seils Thu, 07/01/2010 - 06:41
User Badges:
  • Cisco Employee,

The scheduled start time for the PP job is based on the local time of the (edge) device performing the preposition.


Regards,

Zach

Actions

This Discussion