Bulk FXO device?

Unanswered Question
Jun 29th, 2010

My customer is intended to run FXO instead of PRI for billing purpose. They need 48 Port FXO termination. I fear  that VG-248 is intended for FXS termination. Is there any device  available to serve this purpose?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
William Bell Tue, 06/29/2010 - 06:08

By billing I assume you mean cost?  You are correct the VG248 will not help you.  You would need a high density FXO or DID solution (depending on what you need and how you configure trunks from carrier).  Take a look here:

http://www.cisco.com/en/US/docs/routers/access/interfaces/nm/hardware/installation/guide/exvoimod.html

http://www.cisco.com/en/US/products/hw/modules/ps2617/products_configuration_example09186a0080513001.shtml

Analog DID requires you to order that particular service from your carrier.  I haven't used these interfaces in production (well, not as analog DID anyway).  So you may want to research that a little.

HTH.

Regards,

Bill

Actions

This Discussion