Hi,
I have a 3Mb DSL service and the virtual interface doesn't read the
bandwidth allocation correctly.
Note I use QoS on the dialer with ppp multilink which creates a MLP Bundle and a Virtual Interface which is listed as vi3
!
interface Dialer3
description PPPoA Dialer to iExec
bandwidth 3072
ip address negotiated
encapsulation ppp
dialer pool 3
dialer idle-timeout 0
dialer-group 3
no cdp enable
ppp authentication chap callin
ppp chap hostname xxxxxx@ggg.com
ppp chap password 7 xxxxxxxxxxxx
ppp multilink
service-policy output QoS_Policy
end
sh policy-map int di3
Dialer3
Service-policy output: QoS_Policy
Class-map: Platinum_Queue (match-any)
3661422 packets, 1024444024 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp ef (46)
3661422 packets, 1024444024 bytes
5 minute rate 0 bps
Match: ip precedence 5
0 packets, 0 bytes
5 minute rate 0 bps
Queueing
Strict Priority
Output Queue: Conversation 264
Bandwidth 33 (%)
Bandwidth 1013 (kbps) Burst 25325 (Bytes) --> correct showing
(pkts matched/bytes matched) 0/0
(total drops/bytes drops) 0/0
sh run int vi3
interface Virtual-Access3
bandwidth 3072
no ip address
service-policy output QoS_Policy
end
sh policy-map int vi3
Virtual-Access3
Service-policy output: QoS_Policy
Class-map: Platinum_Queue (match-any)
184 packets, 33837 bytes
5 minute offered rate 0 bps, drop rate 0 bps
Match: ip dscp ef (46)
184 packets, 33837 bytes
5 minute rate 0 bps
Match: ip precedence 5
0 packets, 0 bytes
5 minute rate 0 bps
Queueing
Strict Priority
Output Queue: Conversation 264
Bandwidth 33 (%)
Bandwidth 337 (kbps) Burst 8425 (Bytes) --> Incorrect showing
(pkts matched/bytes matched) 12194/3404574
(total drops/bytes drops) 0/0
sh run int vi 2 --> Interface associated with PPPoATM
!
interface Virtual-Access2
bandwidth 1024
no ip address
end
!
it is showing only 1024K bandwidth allocation on the vi3 and I have 3072 configured.
Does it matter, because the site is having phone related issues.
thanks,