Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)??

Unanswered Question
Jul 1st, 2010
User Badges:

Is possible configure fail to wire in a PIX working on Transparent firewall mode, to allow pass all the traffic in case of shutdown o reset the PIX?


Thanks


Best regards.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
juancarlosmarti... Fri, 07/02/2010 - 00:32
User Badges:

I want say, with a single PIX, if I turn it off or restart it, if PIX allows traffic to pass through it like a cable


Thanks

Jennifer Halim Fri, 07/02/2010 - 01:36
User Badges:
  • Cisco Employee,

OK, thanks for the clarification.


The answer is no, if you reset the PIX firewall or turn it off, it will not pass any traffic at all.

Actions

This Discussion

Related Content