cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1467
Views
0
Helpful
3
Replies

Fail to Wire in Cisco Pix 525 (on Transparent Firewall mode)??

Is possible configure fail to wire in a PIX working on Transparent firewall mode, to allow pass all the traffic in case of shutdown o reset the PIX?

Thanks

Best regards.

3 Replies 3

Jennifer Halim
Cisco Employee
Cisco Employee

Yes, failover is possible for PIX 525 in transparent mode.

For Active/Standby failover, here is the configuration guide:

http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html#wp1058096

Hope that helps.

I want say, with a single PIX, if I turn it off or restart it, if PIX allows traffic to pass through it like a cable

Thanks

OK, thanks for the clarification.

The answer is no, if you reset the PIX firewall or turn it off, it will not pass any traffic at all.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: