cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
592
Views
0
Helpful
2
Replies

snmp v3 *tv error

mhafbnet
Level 1
Level 1

When devices on our network lose power or reload for whatever reason, we are losing our v3 snmp command to what seems to be a default value inserted by the devices. when this happens, we lose reachability with ciscoworks, and it requires we go back into the device and reapply the command below.

the command we are using:

snmp-server group $$Value$$ v3 auth

the sh run command after a reload:

snmp-server group $$Value$$ v3 auth notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF7F

we have tried placing strings at the end of our snmp command, to see if we could stop the default placement of the *tv string to include

read, write, and notify strings with no success. we have noticed that the devices are also placing v1 and v2c snmp groups with the *tv string in the notify field, on every reload.

Thank you for your help!

-fox

2 Replies 2

yjdabear
VIP Alumni
VIP Alumni

Here's a potential workaround to your problem:

https://supportforums.cisco.com/message/3120162#3120162

thank you for the help. i literally found this 2 hours before you replied. im still working it, but ill post when i find

out if it works.

thanks again

-fox

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco