conference pass code works from Avaya system but not from Cisco IP phones

Unanswered Question
Jul 1st, 2010

We have a conference call service set up on number 650-385-XXXX plus a 6 digit pass code. Pound symbol (#) is not required after pass code.
The conference pass code works from  Avaya system but not from Cisco IP phones.

We are using AT&T IP Gateway to route the conference call using our CUBE router.

CUBE router configuration is following.


!
voice service voip
allow-connections h323 to h323
h323
no h225 timeout keepalive
h225 id-passthru
h225 connect-passthru
call start interwork
h245 caps mode restricted
h245 passthru tcsnonstd-passthru
!
!

On the vOIP dial-peer which is sending call to AT&T IP GW using dtmf-relay h245-alphanumeric.


Appreciate if one can provide the fix for it.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion