07-03-2010 11:00 AM - edited 03-06-2019 11:53 AM
Hi CSC,
Have a general question about the implementation of Storm Control in the access layer.
The answer is likely a "it depends" on your environment, but in gerneral what would be a good percentage to start with for implementing storm control in the access layer where end users/end user devices (printers, etc...) connect? Assuming the access switches are a mix of 3550/3560/3750 10/100. I was thinking around 50 percent to start with (for some broadcast storm protection), but was curious to hear from those that have implemented.
Thanks,
Brandon
07-03-2010 12:06 PM
Hello Brandon,
we have used 1% on GE ports with /24 IP subnets
I could guess 10% on FE ports should be fine.
The size of the IP subnet counts
Hope to help
Giuseppe
07-03-2010 01:00 PM
Hi Giuseppe,
Thanks for the reply. I do appreciate it.
Thanks,
Brandon
07-08-2010 07:24 AM
I am also looking into setting up storm/broadcast control and very interested. We have variously sized subnets as well as supernets. How exactly would you factor in network size to setup some starting settings?
Thank you.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide