07-04-2010 04:54 PM - edited 03-17-2019 10:03 PM
Hi all,
Just a quick one, how do I set a Cisco SD IP Camera Indoor Dome 2420 Series back to factory default settings?
I have 4 Cisco cameras setup but for some reason I cannot access the 4th camera.
On the router, I can see arp entry but it is incomplete. All 4 camera is setup in a VLAN which has DHCP enable.
Thanks
Solved! Go to Solution.
07-06-2010 09:04 PM
There is a reset button on the rear of the device. You can perform various resets based on how long you hold the reset button. Check out the info here:
Hailey
Please rate helpful posts!
07-06-2010 09:04 PM
There is a reset button on the rear of the device. You can perform various resets based on how long you hold the reset button. Check out the info here:
Hailey
Please rate helpful posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide