Cisco WAAD Deployment with Allot Netenforcer

Unanswered Question
Jul 5th, 2010
User Badges:

Hi,


While deploying Cisco waas in inline mode with allot,I am facing interface issues.

Set up is like  router-->cisco waas-->allot-->l2 switch.


Can you pleas hep.


Regards

Ravi

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tgervais Mon, 07/05/2010 - 01:55
User Badges:

Hi Ravi,


I've had interface issues with inline cards whenever there's a speed difference, ie. 100m vs 1gb, etc, with the LAN/WAN endpoints. I'm not sure what type of interfaces your Netenforcer uses, but the following link may be helpful.


http://conft.com/en/US/docs/app_ntwk_services/waas/wae/module/inline/installation/guide/17880fru.html#wp39911


You may need a crossover cable somewhere inline.


Hope this helps.

robertsoto Tue, 07/19/2011 - 22:25
User Badges:

Hi dear,


I will apreciate that you send the LINK again , becouse when I try to opened the link not reponse.


I have a same case the Ravi.


SW --> WAAS --> ALLOT --> ROUTER.


I need information about the issue when in the implementation is the ALLOT with the WAE.

ravi.kumar6 Tue, 07/19/2011 - 22:44
User Badges:

Hi,



Yes there is challenge in placing the WAAS device in inline mode and its is not with waas but with any wan optimization device.



Best way is to use WCCCP mode and redirect some specific traffic . If everything goes well, you can redirect the complete subnet using WCCP mode.




Regards,



Ravi Kumar


Technical Specialist- ITS


GSM:+91-9810908415

Actions

This Discussion