Megacom not working for both LD and Int'l

Unanswered Question
Jul 6th, 2010

I got the same issue described here but only differences are my setup is using CCM 4.2 and Cisco 3845's.

To make a LD call to work, I got to set the "Called party IE number type" under the GW config to National; and

To make an Int'l call to work, I got to set this value to International.

If I leave everything default, i.e. Cisco CallManager, only LD works.

Basically, I couldn't make both LD and Int'l to work. It's either one way or the other.

Any workaround to make both to work would be greatly appreciated.



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)


This Discussion