Help with set ip next-hop recursive

Unanswered Question
Jul 6th, 2010

I don't understand the  concept of the set ip next-hop  recursive under a route map.  Any help will be very appreciated

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Reza Sharifi Tue, 07/06/2010 - 18:33

Hi Luis,

This command is mostly used when you are deploying PBR.

The set ip next-hop command verifies the existence of the next hop specified, and…

  • if the next hop exists in the routing table, then the command policy routes the packet to the next hop.

  • if the next hop does not exist in the routing table, the command uses the normal routing table to forward the packet.

Have a look at this document for more info:

http://www.cisco.com/en/US/tech/tk364/technologies_configuration_example09186a00801f3b54.shtml#casetwo

HTH

Reza

Actions

This Discussion