Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
394
Views
0
Helpful
5
Replies

APS not working

mailaglady2
Level 1
Level 1

‎07-07-2010 01:28 AM - edited ‎03-04-2019 08:59 AM

Hi All

I have two routers (7613 and 6509) connceted point-to-point with STM1 cards, APS is working correctly between these two router connected point-to-point but once the SDH equipment is attached then my APS is not working no more. Can you please assist in determining what could be a problem.

I have attached the configurations.

Labels:
68800-APSconf(W).txt.zip
0 Helpful
5 Replies 5

vmiller
Level 7
Level 7

‎07-07-2010 07:25 AM

Whose SDH gear is connected to the 6500 and 7600 ? How is it configured?

My guess is that is where the problem lies.

0 Helpful

mailaglady2
Level 1
Level 1
In response to vmiller

‎07-07-2010 12:10 PM

Is my configuration look good/correct?

0 Helpful

vmiller
Level 7
Level 7
In response to mailaglady2

‎07-07-2010 12:16 PM

Noting jumped out as wrong. What is the terminating hardware upstream from the routers ? If it is not configured for APS, yours won't work.

0 Helpful

mailaglady2
Level 1
Level 1
In response to vmiller

‎07-07-2010 03:04 PM

I have a chanelised STM1 card from the 7613 router connected to an SDH equipment with a fibre.

0 Helpful

vmiller
Level 7
Level 7
In response to mailaglady2

‎07-08-2010 07:33 AM

What hardware is the SDH device?

Who configures it ?

Is your link on this device configured for APS ?

Same holds true for the far end.

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card