Using BRI interface on NM-4B-S/T

Unanswered Question
Jul 7th, 2010

Hi all,

I've got a Cisco 2821 with

2 x VWIC-2MFT-T1/E1 (slot0/subslot0 - slot0/subslot1)

1x NM-4B-S/T (slot1)

I want my fax server (connected to the BRI1/0 on the NM-4B-S/T) to communicate with PSTN through gateway and CUCM6.1.3.

Cisco 2821 registered in MGCP in the CUCM for the E1 access, registered in H323 for the BRI interface.

I configured the following on my gateway (for outgoing call from the BRI interface)


dial-peer voice 2 voip

destination-pattern .T

session target ipv4:10.XX.XX.XX


How can I do for incoming calls (fax), except route list in the CUCM to route calls from E1 access to the H323 gateway.

I can not configure dial peer pots because there are no voice port with the NM-4B-S/T.

Thanks a lot for your help.


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
ttortelier Sat, 07/10/2010 - 09:46

Ok, thank you for your answer, but, to what extend can I use this card?



Paolo Bevilacqua Sat, 07/10/2010 - 16:19

It can be used for data calls only.

Please remember to rate useful posts clicking on the stars below.


This Discussion