07-07-2010 01:35 AM - edited 03-15-2019 11:35 PM
Hi all,
I've got a Cisco 2821 with
2 x VWIC-2MFT-T1/E1 (slot0/subslot0 - slot0/subslot1)
1x NM-4B-S/T (slot1)
I want my fax server (connected to the BRI1/0 on the NM-4B-S/T) to communicate with PSTN through gateway and CUCM6.1.3.
Cisco 2821 registered in MGCP in the CUCM for the E1 access, registered in H323 for the BRI interface.
I configured the following on my gateway (for outgoing call from the BRI interface)
!
dial-peer voice 2 voip
destination-pattern .T
session target ipv4:10.XX.XX.XX
!
How can I do for incoming calls (fax), except route list in the CUCM to route calls from E1 access to the H323 gateway.
I can not configure dial peer pots because there are no voice port with the NM-4B-S/T.
Thanks a lot for your help.
Thomas
07-09-2010 02:15 AM
Someone please help me ?
07-10-2010 04:51 AM
NM-4B-S/T does not support voice. Must use VIC2-2BRI-NT/TE instead.
07-10-2010 09:46 AM
Ok, thank you for your answer, but, to what extend can I use this card?
Regards,
Thomas
07-10-2010 04:19 PM
It can be used for data calls only.
Please remember to rate useful posts clicking on the stars below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide