07-07-2010 01:35 AM - edited 03-15-2019 11:35 PM
Hi all,
I've got a Cisco 2821 with
2 x VWIC-2MFT-T1/E1 (slot0/subslot0 - slot0/subslot1)
1x NM-4B-S/T (slot1)
I want my fax server (connected to the BRI1/0 on the NM-4B-S/T) to communicate with PSTN through gateway and CUCM6.1.3.
Cisco 2821 registered in MGCP in the CUCM for the E1 access, registered in H323 for the BRI interface.
I configured the following on my gateway (for outgoing call from the BRI interface)
!
dial-peer voice 2 voip
destination-pattern .T
session target ipv4:10.XX.XX.XX
!
How can I do for incoming calls (fax), except route list in the CUCM to route calls from E1 access to the H323 gateway.
I can not configure dial peer pots because there are no voice port with the NM-4B-S/T.
Thanks a lot for your help.
Thomas
07-09-2010 02:15 AM
Someone please help me ?
07-10-2010 04:51 AM
NM-4B-S/T does not support voice. Must use VIC2-2BRI-NT/TE instead.
07-10-2010 09:46 AM
Ok, thank you for your answer, but, to what extend can I use this card?
Regards,
Thomas
07-10-2010 04:19 PM
It can be used for data calls only.
Please remember to rate useful posts clicking on the stars below.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: