Using BRI interface on NM-4B-S/T

ttortelier · ‎07-07-2010

Hi all,

I've got a Cisco 2821 with

2 x VWIC-2MFT-T1/E1 (slot0/subslot0 - slot0/subslot1)

1x NM-4B-S/T (slot1)

I want my fax server (connected to the BRI1/0 on the NM-4B-S/T) to communicate with PSTN through gateway and CUCM6.1.3.

Cisco 2821 registered in MGCP in the CUCM for the E1 access, registered in H323 for the BRI interface.

I configured the following on my gateway (for outgoing call from the BRI interface)

!

dial-peer voice 2 voip

destination-pattern .T

session target ipv4:10.XX.XX.XX

!

How can I do for incoming calls (fax), except route list in the CUCM to route calls from E1 access to the H323 gateway.

I can not configure dial peer pots because there are no voice port with the NM-4B-S/T.

Thanks a lot for your help.

Thomas

ttortelier · ‎07-09-2010

Someone please help me ?

paolo bevilacqua · ‎07-10-2010

NM-4B-S/T does not support voice. Must use VIC2-2BRI-NT/TE instead.

ttortelier · ‎07-10-2010

Ok, thank you for your answer, but, to what extend can I use this card?

Regards,

Thomas

paolo bevilacqua · ‎07-10-2010

It can be used for data calls only.

Please remember to rate useful posts clicking on the stars below.