7200vxr with new NPE-G2

Unanswered Question
Jul 7th, 2010

Has anyone had any issues with installing the new NPE-G2 in the 7200 vxr?  The board doesn't seem to want to even seat into the chassis???

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
gephelps Sun, 07/11/2010 - 09:38

I have seen some older chassis in the lab where there was a very tight fit. I have also replaced a chassis for a customer and that resolved the fitment issue. Did you have an older NPE model in this same chassis?

The NPE-G2 still installs into the NPE slot on the chassis (the side with the power supplies). I have also seen a Service Request where the problem was the customer was trying to install the NPE-G2 into the I/O slot.

Actions

This Discussion