1300 bridge question

Answered Question
Jul 7th, 2010

Hello,

I'm new to the community and wanted to see if I could receive a little assistance with a question I had regarding the Aironet 1300 wireless bridge.

Is there a way to statically assign only one MAC address for the bridge to connect to instead of roaming to the strongest signal?

I have this problem too.
0 votes
Correct Answer by dancampb about 6 years 6 months ago

Sure.  On the non-root bridge you could define the parent under the radio interface and define the root bridge's mac address.

On the root bridge you could configure an association access-list to only allow the non-root

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
dancampb Wed, 07/07/2010 - 09:07

Sure.  On the non-root bridge you could define the parent under the radio interface and define the root bridge's mac address.

On the root bridge you could configure an association access-list to only allow the non-root

Vinay Sharma Sun, 05/29/2011 - 07:39

Hi,

Please mark the Question as Answered if the provided information is correct and issue is fixed.

thanks,
Vinay

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode