Disable Port Link State Logging

Answered Question
Jul 7th, 2010
User Badges:

Hello,


I have a Catalyst 3560 configured to send syslog messages to a syslog server.  This switch has a host plugged into one of its edge ports which resets its link state every 20 minutes (due to an intentionally configured 20-minute restart interval).  I'd like to turn off the logging of this (and only this) specific event.  I wasn't able to have much luck with searching.


Any guidance would be appreciated.


Thanks,

Correct Answer by Joe Clarke about 6 years 8 months ago

Under the interface configuration for the port, add these two commands:


no logging event link-status

no snmp trap link-status

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Joe Clarke Thu, 07/08/2010 - 16:20
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Under the interface configuration for the port, add these two commands:


no logging event link-status

no snmp trap link-status

Actions

This Discussion