cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
963
Views
9
Helpful
8
Replies

Cannot log in on ASDM

HMidkiff
Level 1
Level 1

I had ASDM working on the management interface and then I changed the IP address.  When I did that I can not get into anymore.   I have "http server enable" and "http x.x.x.x x.x.x.x management".  I can ping the interface so I know I can get to it.  I even redid the key but still can not get in.  Anyone have any ideas?

Harrison Midkiff

1 Accepted Solution

Accepted Solutions

So are you able to access the ASDM now?

Regards,

NT

Note: Do not forget to rate the useful posts.

View solution in original post

8 Replies 8

Panos Kampanakis
Cisco Employee
Cisco Employee

I would suggest to you to remove the http commands and put them back.

then try again.

If it still doesn't work do "debug http" and check what the ASA spits out for http as you try to ASDM to it.

I hope it helps.

PK

PK

Thanks for replying....

I tried both but no luck.  Debugging did not generate any output.  Still trying to figure it out.

Harrison

Something is denying the traffic.

Any logs that show your client trying to connect or being denied?

Can you try changing the http port "http server enable 444" and connect to it and see if that makes a difference? Just as a test...

PK

I found something interesting.  I enable syslog and this is the error I got

Routing failed to locate next hop for TCP from MANAGEMENT:X.X.12.9/443 to MANAGEMENT:X.X.10.5/1618

Routing failed to locate next hop for TCP from MANAGEMENT:X.X.12.9/443 to MANAGEMENT:X.X.10.5/1619

It is some kind of routing problem....

Are you trying to access the management IP address from inside hosts? Are you sharing a layer 3 switch for both management and inside network? If that is the case, I guess you could be facing some sort of assymetric routing issue. Try accessing the inside interface IP instead of Management IP and see if that helps.

Regards,

NT

NT

Thanks for replying to my post.

That go me in!  My goal is to access the ASA via the management interface.  Right now it is in a lab environment while I configure it.

Thanks again.

So are you able to access the ASDM now?

Regards,

NT

Note: Do not forget to rate the useful posts.

Yup...........

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card