07-08-2010 04:21 AM - edited 03-06-2019 11:56 AM
We have two router R1 and R2 and R2 have on configure 3 different line but default is 0 3 now I want to direct access on line 5 10 as show in picture, so please suggest me how I can telnet to direct on line 10 to 15 or any other line from R1 to R2 but not on default.
Solved! Go to Solution.
07-08-2010 10:04 PM
Good , nice application.
07-08-2010 10:13 PM
Hi Dear Friends,
I got the answer from cisco doc. we have configure the Rotory command on line with specific no. like below.
!
!
line con 0
transport input none
line aux 0
line vty 0 3
password cisco
login
rotary 2
line vty 4
password network
login
rotary 3
line vty 5 10
password abhinay
login
rotary 1
!
endR2#
R2#
Thanks for providing a new thing,learned a new thing today !!
Ganesh.H
07-08-2010 05:44 AM
We have two router R1 and R2 and R2 have on configure 3 different line but default is 0 3 now I want to direct access on line 5 10 as show in picture, so please suggest me how I can telnet to direct on line 10 to 15 or any other line from R1 to R2 but not on default.
Hi,
If you want to use specifc vty session, you can use if you have configured password under vty like in your case you have already configured password at different vty lines
vty 0 3
password cisco
login
vty 4
password network
login
vty 5 10
password abhinay
login
so if you type the password abhinay you will land up in vty session 5 and if another user try and type the same password he will landup in vty session 6 like that.
Hope to Help !!
Ganesh.H
Remember to rate the helpful post
07-08-2010 06:14 AM
No yar its not done u check one i did same process....
07-08-2010 08:55 PM
Hi Dear Friends,
I got the answer from cisco doc. we have configure the Rotory command on line with specific no. like below.
!
!
line con 0
transport input none
line aux 0
line vty 0 3
password cisco
login
rotary 2
line vty 4
password network
login
rotary 3
line vty 5 10
password abhinay
login
rotary 1
!
end
R2#
R2#
after that come on R1 and #telnet 10.0.0.2
so my orignal command from R1 to R2 telnet is :
R1#telnet 10.0.0.1 3003
Passwod: network
07-08-2010 10:04 PM
Good , nice application.
07-08-2010 10:13 PM
Hi Dear Friends,
I got the answer from cisco doc. we have configure the Rotory command on line with specific no. like below.
!
!
line con 0
transport input none
line aux 0
line vty 0 3
password cisco
login
rotary 2
line vty 4
password network
login
rotary 3
line vty 5 10
password abhinay
login
rotary 1
!
endR2#
R2#
Thanks for providing a new thing,learned a new thing today !!
Ganesh.H
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide